CNC Stepper motor mech Rack & Gear 96" Rack (4-24" pcs) & a 20T 8mm pinion gear

Description

PLEASE DON'T ORDER UNTIL MAY 30th.
WE CANNOT DELIVER THIS ITEM  UNTIL MAY 30 DUE TO AN INTERNATIONAL BANKING ERROR.
We are keeping the ad up so we don't loose our place in listing order and to keep you informed. thank you
There is a slight change in dimensions
This is a 96 inch long rack  (4  24' long racks that butt up to each other) with 6.35 teeth per inch.  This rack has threaded holes on the bottom and through the sides so you can bolt it down and you can order multiple racks to make as long a run as you need. The rack
is 3/8" wide and  is 30mm or 1.1/8" tall
to the top of the gears from the base. They will butt up against each other and work as one continuous piece. There are six mounting wholes on the underside and five mounting wholes through the sides.
Rack specks
0.4" or almost 1/2" width wide  24" long  and 1.3/16"  tall   and can but end to end for long continuous drive distances  Mounting holes on the underside opposite the gear side with 1/4-20 threaded holes  starting 2" in from each end and every 4" to the other end and now there are also through the side mounting holes also with 1/4-20 threaded holes that are 60.96mm or 2.4' from the end and 121.92mm or 4.8' spacing. The side mount holes are 6.35mm or 1/4' from the base to the center of the hole.
The gears in this system are 20 Degree pressure angle
6.35 TPI
with this order you get 1 15T 10mm pinion Gear
The total retail value:
Pinion gear = .99
rack 4 x .99 = 3.96
Total = 9.95
The combined shipping on this combo pack is much more cost effective than ordering the parts individually.
Important note about SHIPPING:
·
ON
Multiple item orders only,
NOT on single item orders
,
SHIPPING COST totals can become UNREASONABLY HIGH due to the necessity for Ebay to add up all of the individual shipping costs for an estimated “not to exceed” total ship cost.
A high ship cost total on your order will be corrected by us, but only if you place your multiple order and WAIT to PAY,  UNTIL after we send you an invoice with COMBINED shipping.
Don’t use a cart
to order your multiples because it forces you to pay immediately on checkout, and, we can’t then invoice you for combined shipping on your order once you have paid.
THE MESSAGE ABOVE ONLY APPLIES TO PEOPLE ORDERING MORE THAN ONE TYPE OF ITEM FROM OUR STORE!
PROBLEMS with the Shipment -- Communicate with us ONLY BY
EBAY MESSAGE.
DO NOT communicate with the paypal email beginning alice.hubbard, this is an order Depository email only, we do not monitor it.
Thanks for reading and be sure to Google Hubbard CNC to see our glowing reviews and other spectacular deals we have online!
Each multi-piece rack comes with an alignment tool and instructions to ensure you are getting consistent motion in the pinion gear trave